|
Who's Online
There currently are 6013 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very professional seller; very fast, accurate and rielable service.
;
great works fine, got the manual on mail within a day
;
First class Service,
best quality, come again
Thank You.
vac
;
I didn't realise a manual for an early plasma TV such as the one we were gifted could be so easily obtained. No manual was supplied with it, and as senior citizens we were a little puzzled over some aspects of its use. I do not want a listing for your store credit as we are not fairly big computer users. The manual was well organised, as it should be, with its backing of the Pioneer name. The download was prompt and everything worked quite smoothly. Thank you. Gordon.
;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
Reference Notes in the Table
CAUTION! When removing the CRT, be sure to discharge the Anode Lead of the CRT with the CRT Ground Wire before removing the Anode Cap. 1. CAUTION 1: Discharge the Anode Lead of the CRT with the CRT Ground Wire before removing the Anode Cap. Disconnect the following: Anode Cap, CN2501, CRT CBA, CN1601, CN3802, CN2571 and CN3801. Then remove Tray Chassis Unit. 2. CAUTION 2: Electrostatic breakdown of the laser diode in the optical system block may occur as a potential difference caused by electrostatic charge accumulated on cloth, human body etc., during unpacking or repair work. To avoid damage of pickup follow next procedures.
1) Disconnect Connector (CN301) on the DVD Main CBA Unit. 2) Short the three short lands of FPC cable with solder before removing the FFC cable (CN201) from it. If you disconnect the FFC cable (CN201), the laser diode of pickup will be destroyed. (Fig. D4) 3) Remove DVD Mechanism. 3. CAUTION 3: When reassembling, confirm the FFC cable (CN201) is connected completely. Then remove the solder from the three short lands of FPC cable. (Fig. D4) 4. Remove three screws (S-7) and remove Top Shield. Remove screws 5(S-8), (S-9) and (S-10). Then, desolder connectors (CL1201, CL1401, CL1402, CL1403) and lift up the Deck Assembly.
(S-1) (S-1)
(S-2) (S-3A) (S-1) (S-1) (S-3B)
(S-1)
[1] Rear Cabinet
Fig. D1
1-6-2
T2203DC
|
|
|
> |
|